Casting related products

Aqueous release agent for green sand

SHIFT MOLD W-8 (spray over the pattern)

  • aqueous release agent
  • undiluted solution use
  • colloidal solution,low viscosity,our patent
Aqueous release agent for green sand@SHIFT MOLD W-8 (spray over the pattern)

Use
SHIFT MOLD W-8 is special colloidal solution and new type release agent for mold sand used for large sized high pressure molding machine or DISAMATIC molding machine.
Please used undiluted.
Feature
-Superior on stability than W/O emulsion type currently in use..
-Moisture rate is similar with green sand therefore does not influence to green sand moisture condition.
- Residual moisture is limited hence can protect from the gathering rust, which is better comparing with W/O emulsion type currently in use.
- Mineral oil is used as the base oil and no flash point is recognized although the low water content.
- Friction coefficient is low therefore good molding performance and good at release the mold.
- Low viscosity therefore good to spray.
- It is possible to reduce the consume volume to half comparing to the oil based type currently in use at good condition therefore economical.
- Antiscattering agent is added therefore good for working environment because the products does not drift as the mist.
Property
AppearancePale yellowish white
Density15Ž@g/cm30.841
Flash pointCOC ŽNo flash point
Viscosity40Ž mm2/s3.69
MoistureWT%8.0
pHLiquid concentrate7.0
Remarks
-PCA control EPCA which is called carcinogen is under 3% as per EU standard hence safe.
- Heavy metal which is harmful to human body is not used.
How to use
1.Please use undiluted solution. (do not dilute by water)
2. Please spray evenly onto the surface of the pattern, which makes Green Sand Mold.
3. Spray by each mold. Subject to the condition, spray once per 2~3 mold can be effective.
Packing
18 liter Can
200 liter Drum
SHIFT CHEMICAL CO., LTD.